Automatic Tool Changer for Kress 800W Spindle

$899.00

With the Automatic Tool Changer for the Kress 800 FME 800 watt spindle a time consuming manual exchange of tools is no longer required. After once defining the parameters in the machine control software, the magazine is approached automatically. With the use of compressed air, a tool is returned or a new one collected. The supplied magazine can hold up to six tools and is optionally extendable for up to twelve.

The Tool Changer for Kress comes with the Switch-Box and two Tool Holders.

Additional Tool holders  with appropriate ER11 collets have to be purchased separately as well as the Switchable Socket which is needed for operating the device.

NOTE: You MUST purchase the REMOTE SWITCHABLE POWER CONTROLLER in order for the Tool Changer to work.  This will electronically interface the Kress with the Stepcraft, turning the power off on it during tool changes and turning it back on when the tool change is complete.

You will also need 100PSI of compressed air.

  • SK 15 tool holders for ER11 collets from 1 to 8 mm
  • Double ball bearing
  • Active sealing air
  • Suitable for speeds up to 30.000 UpM
  • Operating pressure: 8 bar
  • Shaft diameter: 43 mm
  • Diameter: 56 mm
  • Length (without tool holder): 100 mm
  • Weight: 585 g
  • 1x Tool Changer for Kress
  • 1x Magazine to hold up to 6 tools
  • 1x Switch Box
  • 2x Tool Holders
  • 1x ER11 1/8″ collet
  • 1x ER11 1/4″ collet

Additional information

Weight 7 lbs
Dimensions 12 x 12 x 8 in

Reviews

There are no reviews yet.

Be the first to review “Automatic Tool Changer for Kress 800W Spindle”

Your email address will not be published. Required fields are marked *